Product Manual - ZMORPH i500 back to table of content
>>
27
Setting up Zmorph i500
At least two people are required to lift the machine.
Ensure that you have enough room to unbox the
printer to its nal location.
Firmly grab it on both sides, approximately above the
middle point and lift the machine up.
Depending on the user
height the carrying
straps have 3 dierent
sleeve positions to put
the forearms in them.
We recommend that you do not throw away the
straps in the event of possible transport of the
machine
NOTE
Place the machine in its nal location and pull out
the carrying straps from underneath.
It may be necessary to allow the printer to adjust
to temperature change before powering it up if it
have been subjected to extended periods of cold
during storage or transportation.
Exposure to extended periods of cold can cause
condensation in the device when it is moved
into warmer areas. Condensation on the printer
indicates the need for an acclimation period until
the condensation disappears.
The machine should be stable
on the at surface. If necessary,
adjust the leveling legs.
To Next Page
Loading...
Need help?
General
