Notes about the looper tempo
• The looper tempo is also used by effects and rhythms.
• The tempo can be set as explained in “Adjusting the master tempo” on page 55 and “Adjusting the tempo”
on page 80.
• Changing the tempo will delete the recorded data.
NOTE
• If the pre-count function is ON (
→
“Setting the precount” on page 79), recording will start after the pre-
count.
• Sound input through the AUX IN jack will not be recorded.
• See “Setting the looper” on page 32 for recording time, volume and other settings.
HINT
• Using an SD card, loops can be recorded for longer times and saved. Moreover, loops on the SD card can be
recalled for playback and overdubbing. (
→
“Using SD cards” on page 37)
• During rhythm playback (
→
page77), quantization is enabled so even if the recording ending time is not
exact, the loop will automatically be adjusted so that loop playback stays in time.
• Different play modes can be selected and the Menu Screen can be opened during loop playback. This allows
patch memories to be selected and rhythms to be used, for example, while the loop continues to play.
To stop loop playback when doing other operations, press repeatedly and select or touch
on the Menu Screen. Then, stop playback.
When other play mode screens are open, the looper playback status is shown at the top left.
Playing back
Recording
Stopped
Overdubbing
31
To Next Page
Loading...
