Zoom G6 - Loading Impulse Response Data

Loading impulse response (IR) data
You can load your own impulse response data and impulse response data from third parties.
NOTE
Impulse response data in the following format can be loaded.
• Format: WAV
• Sampling frequency: 44.1–192 kHz
1.
Copy impulse response data to an SD card.
Copy impulse response data to the “G6_IR” folder on the SD card. (
→
“G6 folder and file structure” on page
104)
The “G6_IR” folder is created at the top level of an SD card when it is formatted by the
G6
. (
→
“Formatting
SD cards” on page 101)
2.
Insert the SD card (
→
“Inserting SD cards” on page 17).
3.
Touch on the Menu Screen.
4.
Touch for the location where you want to save it.
Impulse response data is already assigned to locations 001–070. You can assign impulse response data as
you like to 071–200.
5.
Touch the impulse response data that was assigned.
87