3.
Select a category.
The category selection screen only appears when DYNMCS/FILTER or DELAY/REVERB is selected. Proceed
to step 4.
4.
Touch an amp or effect to select it. Then, touch OK.
The selected effect or amp will be activated.
5.
Repeat steps 2–4 to select amps and effects.
If the AUTOSAVE function (
→
page94) is ON, the patch memory will be saved automatically.
If the AUTOSAVE function is OFF, touch to open the patch memory saving screen. Follow the procedures
in “Saving patch memories” on page 56 to save it.
61
To Next Page
Loading...
