Chapter 20 Maintenance
LTE2566-M634 User’s Guide
130
Restore configuration allows you to upload a new or previously saved configuration file from your
computer to your LTE2566-M634.
Click Maintenance > Backup/Restore. Information related to factory defaults, backup configuration,
and restoring configuration appears as shown next.
Figure 104 Maintenance > Backup/Restore > Backup/Restore
The following table describes the labels in this screen.
Note: If you uploaded the default configuration file you may need to change the IP address
of your computer to be in the same subnet as that of the default LTE2566-M634 IP
address (192.168.1.1).
Table 52 Maintenance > Backup/Restore > Backup/Restore
LABEL DESCRIPTION
Backup Configuration
Download Click Download to save the LTE2566-M634’s current configuration to your computer.
Restore Configuration
Browse Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Note: Do not turn off the LTE2566-M634 while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the LTE2566-M634 again. The LTE2566-M634 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information and
returns the LTE2566-M634 to its factory defaults.
You can also press the RESET button on the side panel to reset the factory defaults of your
LTE2566-M634. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button. See Section 1.4.3 on page 15.
Apply Click Apply to save your changes back to the LTE2566-M634.
To Next Page
Loading...
