Chapter 8 WLAN
LTE2566-M634 User’s Guide
70
Note: To use the WPS feature, make sure you have wireless enabled in the Configuration >
Network > Wireless LAN > WPS SetUp screen.
Note: If you want to use the WPS feature set the security type to WPA Personal.
Click Configuration > Network > Wireless LAN > WPS SetUp. The following screen displays.
Figure 49 Configuration > Network >Wireless LAN > WPS SetUp
The following table describes the labels in this screen.
8.8 WPS Station
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Configuration > Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station again after the first 2
minutes.
Table 25 Configuration > Network >Wireless LAN > WPS SetUp
LABEL DESCRIPTION
PIN Code Click Enable to activate WPS on the LTE2566-M634.
PIN Number This field is available only when you set PIN Code to Enable.
Select this option and enter the PIN of the device that you are setting up a WPS connection with
and click Apply to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the LTE2566-M634.
To Next Page
Loading...
