LTE3301-M209 User’s Guide
101
CHAPTER 13
Interface Group
13.1 Overview
By default, the four LAN interfaces on the Zyxel Device are in the same group and can communicate
with each other. Creating a new interface will create a new LAN bridge interface (subnet) (for example,
192.168.2.0/24) that acts as a dependent LAN network, and is a different subnet from default LAN
subnet (192.168.1.0/24).
13.2 What You Can Do
• Use the Interface Group screen to create a new interface group (Section 13.3 on page 101).
13.3 Interface Group Screen
You can manually add a LAN/WLAN interface to a new group.
Use the DHCP screen to configure the private IP addresses the DHCP server on the Zyxel Device assigns
to the clients in the default and/or user-defined groups. See Chapter 9 on page 82 for more information.
Use the Interface Group screen to create a new interface group, which is a new LAN bridge interface
(subnet). Click Network > Interface Group to open the following screen.
Figure 69 Network > Interface Group
The following table describes the fields in this screen.
Table 46 Network > Interface Group
LABEL DESCRIPTION
Add Click this button to create a new interface group.
Name This shows the descriptive name of the group.
LAN Interface This shows the interface group.
To Next Page
Loading...
