Chapter 19 Bandwidth Management
LTE3301-M209 User’s Guide
121
You can also use this screen to configure bandwidth management rule for other services or applications
that are not on the pre-defined list of Zyxel Device. Additionally, you can define the IP addresses and
port for a service or application.
Click Management > Bandwidth MGMT > Advanced to open the bandwidth management Advanced
screen.
Figure 83 Management > Bandwidth Management > Advanced
The following table describes the labels in this screen.
19.5.1 Add Bandwidth Management Rule
If you want to create a new bandwidth management rule for a service or application, click the Add
New Rule icon in the Advanced screen. The following screen displays.
Figure 84 Bandwidth Management: Add New Rule
Table 58 Management > Bandwidth Management > Advanced
LABEL DESCRIPTION
Add New Rule Click this to open a screen where you can create a new bandwidth management rule for a
service or application.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Grouping This field displays the IP address or a range of IP addresses of the destination computer for
whom this rule applies.
Service This field displays the protocol and port used for the service.
Control This field displays whether the maximum/minimum bandwidth allowed or a priority level is
specified in the rule.
Reset QoS Rule Click this button to remove all bandwidth management rules.
To Next Page
Loading...
