LTE3301-M209 User’s Guide
98
CHAPTER 12
Routing
12.1 Overview
This chapter shows you how to configure static routes for your Zyxel Device.
The Zyxel Device usually uses the default gateway to route outbound traffic from computers on the LAN
to the Internet. To have the Zyxel Device send data to devices not reachable through the default
gateway, use static routes.
For example, the next figure shows a computer (A) connected to the Zyxel Device’s LAN interface. The
Zyxel Device routes most traffic from A to the Internet through the Zyxel Device’s default gateway (R1).
You create one static route to connect to services offered by your ISP behind router R2. You create
another static route to communicate with a separate network behind a router R3 connected to the
LAN.
Figure 65 Example of Static Routing Topology
12.2 What You Can Do
• Use the Static Route screen to view or configure information for a static route (Section 12.3 on page
99).
• Use the Dynamic Routing screen to enable and configure RIP on the Zyxel Device (Section 12.4 on
page 100).
To Next Page
Loading...
