Chapter 22 Maintenance
LTE3301-M209 User’s Guide
137
Figure 91 Maintenance > Firmware Upgrade
The following table describes the labels in this screen.
Note: Do not turn off the Zyxel Device while firmware upload is in progress!
After you see the Firmware Upload In Process screen, wait two minutes before logging into the Zyxel
Device again.
The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 92 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, an error message appears. Click Return to go back to the Firmware
Upgrade screen.
22.7 Backup/Restore Screen
Backup configuration allows you to back up (save) the Zyxel Device’s current configuration to a file on
your computer. Once your Zyxel Device is configured and functioning properly, it is highly
recommended that you back up your configuration file before making configuration changes. The
backup configuration file will be useful in case you need to return to your previous settings.
Restore configuration allows you to upload a new or previously saved configuration file from your
computer to your Zyxel Device.
Table 66 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
To Next Page
Loading...
