Chapter 1 Introduction
LTE3301-M209 User’s Guide
14
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device to
authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set up
a secure network by themselves.
You can use the WPS button ( ) on the top panel of the Zyxel Device to activate WPS in order to
quickly set up a wireless network with strong security.
1 Make sure the power LED is on (not blinking).
2 Press the WPS button for more than three seconds and release it. Press the WPS button on another WPS-
enabled device within range of the Zyxel Device.
Note: You must activate WPS in the Zyxel Device and in another wireless device within two
minutes of each other.
For more information on using WPS, see Section 4.2 on page 34.
1.7 Hardware
1.7.1 Front Panel
The following graphic displays the front panel of the Zyxel Device.
Figure 1 LTE3301-M209 Front Panel
To Next Page
Loading...
