LTE3301-M209 User’s Guide
116
CHAPTER 18
Remote Management
18.1 Remote Management Overview
Use remote management to control through which interface(s), each service can access the Zyxel
Device.
Note: The Zyxel Device is managed using the Web Configurator.
18.2 What You Can Do
• Use the General screen to change your Zyxel Device’s remote management settings (Section 18.3 on
page 116).
• Use the Remote Management screen to configure through which IP address can access the Zyxel
Device (Section 18.4 on page 118).
18.3 WWW Screen
To change your Zyxel Device’s remote management settings, click Configuration > Management >
Remote MGMT to open the WWW screen.
Note: : You must enable the remote management service in the Configuration >
Management > Remote MGMT > Remote Management screen for the settings in the
WWW screen to take effect.
To Next Page
Loading...
