ZyXEL Communications LTE3301-M209 - Page 117

Chapter 18 Remote Management
LTE3301-M209 User’s Guide
117
Figure 79 Configuration > Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 55 Configuration > Management > Remote MGMT > WWW
LABEL DESCRIPTION
HTTPS
Port You may change the server port number for a HTTPS service if needed. However you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the Zyxel Device
using this HTTPS service.
Secured Client IP Address Select All to allow all computers to access the Zyxel Device using the HTTPS service.
Otherwise, check Selected and specify the IP address of the computer that can
access the Zyxel Device
HTTP
Port You may change the server port number for a HTTP service if needed. However you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the Zyxel Device
using this HTTP service. If you activated UPnP, select WAN to allow the UPnP traffic to
come in from the WAN side successfully.
Secured Client IP Address Select All to allow all computers to access the Zyxel Device using this HTTP service.
Otherwise, check Selected and specify the IP address of the computer that can
access the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your settings and exit this screen.