Chapter 6 WAN
LTE3301-M209 User’s Guide
62
6.7 PIN Management Screen
Use this screen to enable PIN authentication and configure the PIN code. Click Network > WAN > PIN
Management from the Configuration menu.
Figure 36 Network > WAN > PIN Management
The following table describes the labels in this screen.
IPv6 Address
Range(Start)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the IPv6
addresses which are to be allocated.
IPv6 Address
Range(End)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the largest value of the last block of the IPv6
addresses which are to be allocated.
IPv6 Address Lifetime If you select Stateful (DHCPv6), specify how long (in minutes) the IPv6 addresses remain
valid.
Apply Click Apply to save your changes.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 18 Network > WAN > IPv6 (continued)
LABEL DESCRIPTION
Table 19 Network > WAN > PIN Management
LABEL DESCRIPTION
PIN Code Request function Select Enable to turn on PIN code authentication. A PIN (Personal Identification
Number) code is a key to a SIM card. Without the PIN code, you cannot use the SIM
card.
Select Disable to turn off PIN code authentication.
SIM PIN Code If you select Enable, enter the 4-digit PIN code (0000 for example) provided by your
ISP for the inserted SIM card.
Apply Click Apply to save your changes.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
