Chapter 12 Routing
LTE3301-M209 User’s Guide
99
12.3 Static Route Screen
Click Network > Routing > Static Route to open the Static Route screen.
Figure 66 Network > Routing > Static Route
The following table describes the labels in this screen.
12.3.1 Add/Edit Static Route
Click the Add Static Route button or a rule’s Edit icon in the Static Route screen. Use this screen to
configure the required information for a static route.
Figure 67 Network > Routing > Static Route: Add/Edit
Table 43 Network > Routing > Static Route
LABEL DESCRIPTION
Add Static Route Click this to create a new rule.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Destination This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Modify Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the Zyxel Device.
To Next Page
Loading...
