Chapter 7 Wireless LAN
LTE3301-M209 User’s Guide
70
Figure 40 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
7.4 More AP Screen
This screen allows you to enable and configure multiple wireless networks and guest wireless network
settings on the Zyxel Device.
You can configure up to four SSIDs to enable multiple BSSs (Basic Service Sets) on the Zyxel Device. This
allows you to use one access point to provide several BSSs simultaneously. You can then assign varying
security types to different SSIDs. Wireless clients can use different SSIDs to associate with the same access
point.
Table 23 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA-PSK
Compatible
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to your
Zyxel Device.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to all
clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
