Chapter 22 Maintenance
LTE3301-M209 User’s Guide
138
Click Maintenance > Backup/Restore. Information related to factory defaults, backup configuration,
and restoring configuration appears as shown next.
Figure 93 Maintenance > Backup/Restore
The following table describes the labels in this screen.
Note: If you uploaded the default configuration file you may need to change the IP address
of your computer to be in the same subnet as that of the default Zyxel Device IP
address (192.168.1.1). See Appendix A on page 145 for details on how to set up your
computer’s IP address.
Table 67 Maintenance > Backup/Restore
LABEL DESCRIPTION
Backup Click Backup to save the Zyxel Device’s current configuration to your computer.
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Browse... Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click Upload to begin the upload process.
Note: Do not turn off the Zyxel Device while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the Zyxel Device again. The Zyxel Device automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information and
returns the Zyxel Device to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your Zyxel
Device. Refer to the chapter about introducing the Web Configurator for more information on
the RESET button.
To Next Page
Loading...
