Chapter 2 Introducing the Web Configurator
LTE3301-M209 User’s Guide
24
ARP Table ARP Table Use this screen to view the ARP table. It displays the IP and MAC address of
each LAN connection.
Packet Statistics Packet
Statistics
Use this screen to view port status and packet specific statistics.
WLAN Station
Status
Association
List
Use this screen to view the wireless stations that are currently associated to the
Zyxel Device’s 2.4GHz wireless LAN.
LTE Modem
Status
Use this screen to view the detailed information about the LTE module, cellular
interface, and SIM card. You can also view the LTE connection status.
Configuration
Network
WAN Management
WAN
This screen allows you to configure ISP parameters, WAN IP address
assignment, and DNS servers.
Network Scan Use this screen to specify the type of the mobile network to which the Zyxel
Device is connected and how you want the Zyxel Device to connect to an
available mobile network.
IPv6 Use this screen to configure the Zyxel Device’s IPv6 settings.
PIN
Management
Use this screen to enable PIN authentication and configure the PIN code.
Wireless LAN General Use this screen to enable the wireless LAN and configure wireless LAN and
wireless security settings.
More AP Use this screen to configure multiple BSSs on the Zyxel Device.
MAC Filter Use the MAC filter screen to allow or deny wireless stations based on their MAC
addresses from connecting to the Zyxel Device.
Advanced This screen allows you to configure advanced wireless LAN settings.
QoS Use this screen to configure Wi-Fi Multimedia Quality of Service (WMM QoS).
WMM QoS allows you to prioritize wireless traffic according to the delivery
requirements of individual services.
WPS Use this screen to configure the WPS settings.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
WDS Use this screen to enable and configure the WDS settings.
LAN IP Use this screen to configure LAN IP address and subnet mask.
DHCP Server General Use this screen to enable the Zyxel Device’s DHCP server.
Advanced Use this screen to assign IP addresses to specific individual computers based
on their MAC addresses and to have DNS servers assigned by the DHCP server.
Client List Use this screen to view information related to your DHCP status.
NAT General Use this screen to enable NAT.
Port
Forwarding
Use this screen to configure servers behind the Zyxel Device and forward
incoming service requests to the server(s) on your local network.
Port Trigger Use this screen to change your Zyxel Device’s port triggering settings.
ALG Use this screen to enable or disable SIP (VoIP) ALG (Application Layer
Gateway) in the Zyxel Device.
Dynamic DNS Dynamic DNS Use this screen to set up dynamic DNS.
Routing Static Route Use this screen to configure IP static routes.
Dynamic
Routing
Use this screen to enable and configure RIP on the Zyxel Device.
Table 7 Navigation Panel (continued)
LINK TAB FUNCTION
To Next Page
Loading...
