Chapter 4 Tutorials
LTE3301-M209 User’s Guide
37
Follow the steps below to configure the wireless settings on your Zyxel Device.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 2.2 on page 19).
1 Make sure the WIFI button (at the rear panel of the Zyxel Device) is pushed in.
2 Open the Configuration > Network > Wireless LAN > General screen in the AP’s Web Configurator.
3 Confirm that the wireless LAN is enabled on the Zyxel Device.
4 Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Set security mode to WPA2-PSK
and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click Apply.
5 Open the Status screen. Verify your wireless and wireless security settings under WLAN Information and
check if the WLAN connection is up under Interface Status.
Channel 6
Security WPA2-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
To Next Page
Loading...
