Chapter 7 Wireless LAN
LTE3301-M209 User’s Guide
79
Figure 49 Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 32 Network > Wireless LAN > WDS
LABEL DESCRIPTION
WDS Setup
Basic Setting Select Disable to turn off the WDS function on the Zyxel Device.
Select AP+Bridge to have the Zyxel Device function as a bridge and access point
simultaneously.
Select Bridge Only to have the Zyxel Device act as a wireless bridge only.
These fields only shows when you select AP+Bridge or Bridge Only in Basic Setting.
Local MAC Address This shows the MAC address of the Zyxel Device.
Remote MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
