Chapter 9 DHCP Server
LTE3301-M209 User’s Guide
83
Figure 53 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 34 Network > DHCP Server > General
LABEL DESCRIPTION
DHCP Server Select Enable to activate DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients (computers) to obtain TCP/IP configuration at startup from a server. Enable the
DHCP server unless your ISP instructs you to do otherwise. Select Disable to stop the Zyxel
Device acting as a DHCP server. When configured as a server, the Zyxel Device provides
TCP/IP configuration for the clients. If not, DHCP service is disabled and you must have
another DHCP server on your LAN, or else the computers must be manually configured.
When set as a server, fill in the following four fields.
IP Pool Starting Address This field specifies the first of the contiguous addresses in the IP address pool for LAN.
Pool Size This field specifies the size, or count of the IP address pool for LAN.
DHCP Relay Select this option to have the Zyxel Device forward DHCP requests to the DHCP server.
DHCP Server IP This field is configurable only when you select DHCP Relay.
Enter the IP address of the actual remote DHCP server in this field.
To Next Page
Loading...
