Chapter 16 Port Authentication
MES-3728 User’s Guide
148
* Use this row to make the setting the same for all ports. Use this row first and then
make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this to permit MAC authentication on this port. You must first allow MAC
authentication on the Switch before configuring it on each port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 41 Advanced Application > Port Authentication > MAC Authentication (continued)
LABEL DESCRIPTION
To Next Page
Loading...
