ZyXEL Communications MES-3728 - Configuring SNMP

Chapter 30 Access Control
MES-3728 User’s Guide
262
30.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen
to configure your SNMP settings.
Table 100 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
stp STPNewRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP
root switch changes.
MRSTPNewRoot 1.3.6.1.4.1.890.1.5.8.45.36.2.1 This trap is sent when the MRSTP
root switch changes.
MSTPNewRoot 1.3.6.1.4.1.890.1.5.8.45.107.70.1 This trap is sent when the MSTP
root switch changes.
STPTopologyChange 1.3.6.1.2.1.17.0.2 This trap is sent when the STP
topology changes.
MRSTPTopologyChange 1.3.6.1.4.1.890.1.5.8.45.36.2.2 This trap is sent when the MRSTP
topology changes.
MSTPTopologyChange 1.3.6.1.4.1.890.1.5.8.45.107.70.2 This trap is sent when the MSTP
root switch changes.
mactable MacTableFullEventOn 1.3.6.1.4.1.890.1.5.8.45.27.2.1 This trap is sent when more than
99% of the MAC table is used.
MacTableFullEventClear 1.3.6.1.4.1.890.1.5.8.45.27.2.2 This trap is sent when less than
95% of the MAC table is used.
rmon RmonRisingAlarm 1.3.6.1.2.1.16.0.1 This trap is sent when a variable
goes over the RMON "rising"
threshold.
RmonFallingAlarm 1.3.6.1.2.1.16.0.2 This trap is sent when the variable
falls below the RMON "falling"
threshold.