ZyXEL Communications MES-3728 - Syslog Server Setup

Chapter 32 Syslog
MES-3728 User’s Guide
278
Figure 160 Management > Syslog
The following table describes the labels in this screen.
32.3 Syslog Server Setup
Click Management > Syslog > Syslog Server Setup to view the screen as shown next. Use
this screen to configure a list of external syslog servers.
Table 108 Management > Syslog
LABEL DESCRIPTION
Syslog Select Active to turn on syslog (system logging) and then configure the syslog
setting
Logging Type This column displays the names of the categories of logs that the device can
generate.
Active Select this option to set the device to generate logs for the corresponding
category.
Facility The log facility allows you to send logs to different files in the syslog server.
Refer to the documentation of your syslog program for more details.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.