Chapter 4 The Web Configurator
MES-3728 User’s Guide
61
4.3.1 Change Your Password
After you log in for the first time, it is recommended you change the default administrator
password. Click Management > Access Control > Logins to display the next screen.
Figure 23 Change Administrator Login Password
4.4 Saving Your Configuration
When you are done modifying the settings in a screen, click Apply to save your changes back
to the run-time memory. Settings in the run-time memory are lost when the Switch’s power is
turned off.
Click the Save link in the upper right hand corner of the web configurator to save your
configuration to nonvolatile memory. Nonvolatile memory refers to the Switch’s storage that
remains even if the Switch’s power is turned off.
ARP Table This link takes you to a screen where you can view the MAC addresses – IP
address resolution table.
Configure Clone This link takes you to a screen where you can copy attributes of one port to other
ports.
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
