Chapter 4 The Web Configurator
MES-3728 User’s Guide
60
Mirroring This link takes you to screens where you can copy traffic from one port or ports to
another port in order that you can examine the traffic from the first port without
interference.
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to
form one logical, higher-bandwidth link.
Port
Authentication
This link takes you to a screen where you can configure IEEE 802.1x port
authentication as well as MAC authentication for clients communicating via the
Switch.
Port Security This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
Classifier This link takes you to a screen where you can configure the Switch to group
packets based on the specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform
special treatment on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated
queue weights for each port.
VLAN Stacking This link takes you to a screen where you can configure VLAN stacking.
Multicast This link takes you to screens where you can configure various multicast features,
IGMP snooping and create multicast VLANs.
Auth and Acct This link takes you to a screen where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized
DHCP and ARP packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
Diagnostic This link takes you to a screen where you can view system logs and test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log
server.
Cluster
Management
This link takes you to screens where you can configure clustering management and
view its status.
MAC Table This link takes you to a screen where you can view the MAC addresses (and types)
of devices attached to what ports and VLAN IDs.
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
