Chapter 8 Wireless Screen
NWA-3160 Series User’s Guide
134
with other APs (Non-ZyXEL APs may not be able to perform this). 802.1x
authentication information is not exchanged (at the time of writing).
Figure 82 Roaming Example
The steps below describe the roaming process.
1 Wireless station Y moves from the coverage area of access point AP 1 to that of
access point AP 2.
2 Wireless station Y scans and detects the signal of access point AP 2.
3 Wireless station Y sends an association request to access point AP 2.
4 Access point AP 2 acknowledges the presence of wireless station Y and relays this
information to access point AP 1 through the wired LAN.
5 Access point AP 1 updates the new position of wireless station Y.
8.3.7.1 Requirements for Roaming
The following requirements must be met in order for wireless stations to roam
between the coverage areas.
• All the access points must be on the same subnet and configured with the same
ESSID.
To Next Page
Loading...
