Chapter 19 Log Screens
NWA-3160 Series User’s Guide
228
19.4.2 Log Commands
Go to the command interpreter interface (refer to Appendix F on page 339 for a discussion
on how to access and use the commands).
19.4.3 Configuring What You Want the NWA to Log
Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the NWA is to record.
Use sys logs category followed by a log category and a parameter to decide what to
record
Use the sys logs save command to store the settings in the NWA (you must do this in
order to record logs).
19.4.4 Displaying Logs
Use the sys logs display command to show all of the logs in the NWA’s log.
Use the sys logs category display command to show the log settings for all of the log
categories.
Use the sys logs display [log category] command to show the logs in an individual
NWA log category.
Use the sys logs clear command to erase all of the NWA’s logs.
19.4.5 Log Command Example
This example shows how to set the NWA to record the error logs and alerts and
then view the results.
Table 74 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that
category.
ras> sys logs load
ras> sys logs category error 3
ras> sys logs save
ras> sys logs display access
#. time source destination notes
message
0 | 11/11/2002 15:10:12 | 172.22.3.80:137 | 172.22.255.255:137 | ACCESS
BLOCK
To Next Page
Loading...
