Chapter 12 Layer-2 Isolation Screen
NWA-3160 Series User’s Guide
164
12.2.1 Configuring Layer-2 Isolation
Use this screen to specify the configuration for your layer-2 isolation profile.
Select a layer-2 isolation profile in Wireless > Layer-2 Isolation and click Edit
to display the following screen.
Note: When configuring this screen, remember to select the correct layer-2 isolation
profile in the Wireless> SSID > Edit screen of the relevant SSID profile.
Figure 100 Wireless > Layer-2 Isolation Configuration Screen
The following table describes the labels in this screen.
Table 45 Wireless> Layer-2 Isolation Configuration
LABEL DESCRIPTION
Profile Name Type a name to identify this layer-2 isolation profile.
Allow devices
with these MAC
addresses
These are the MAC address of a wireless client, AP, computer or router.
A wireless client associated with the NWA can communicate with
another wireless client, AP, computer or router only if the MAC
addresses of those devices are listed in this table.
To Next Page
Loading...
