ZyXEL Communications NWA-3160 - Configure the SERVER_2 Network

Chapter 3 Tutorials
NWA-3160 Series User’s Guide
62
7 Click the MAC Filter tab. When the MAC Filter screen appears, select
macfilter03’s entry and click Edit.
8 Enter the MAC address of the device Alice uses to connect to the network in Set
1’s MAC Address field and enter her name in the Description field, as shown in
the following figure. Change the Profile Name to “MacFilter_SERVER_1”. Select
Allow Association from the Filter Action field and click Apply.
Figure 42 Tutorial: MAC Filter Edit (SERVER_1)
You have restricted access to the SERVER_1 network to only the networking
device whose MAC address you entered. The SERVER_1 network is now
configured.
3.5.5 Configure the SERVER_2 Network
Next, you will configure the SERVER_2 network that allows Bob to access secure
server 2 and the Internet.
To do this, repeat the procedure in Section 3.5.4 on page 59, substituting the
following information.
Table 7 Tutorial: SERVER_2 Network Information
SSID Screen
Index 4
Profile Name SERVER_2
SSID Edit (SERVER_2) Screen
L2 Isolation L2Isolation04
MAC Filtering macfilter04
Layer-2 Isolation (L2Isolation04) Screen
Profile Name L-2-ISO_SERVER-2
Set 1 MAC Address: 77:66:55:44:33:22
Description: NET_ROUTER