Chapter 15 Rogue AP Detection
NWA-3160 Series User’s Guide
180
15.2.2 Rogue AP Screen
Use this scren to display details of all wireless access points within the NWA’s
coverage area. Click Rogue AP > Rogue AP. The following screen displays.
Figure 113 Rogue AP > Rogue AP
The following table describes the labels in this screen.
Table 52 Rogue AP > Rogue AP
LABEL DESCRIPTION
Rogue AP List This displays details of access points in the NWA’s coverage area
that are not listed in the friendly AP list (see Section 15.2.1 on
page 179)
Refresh Click this button to have the NWA scan for rogue APs.
Index This is the index number of the AP’s entry in the list.
Active Use this check box to select the APs you want to move to the
friendly AP list (see Section 15.2.1 on page 179)
MAC Address This field displays the Media Access Control (MAC) address of the
AP. All wireless devices have a MAC address that uniquely
identifies them.
SSID This field displays the Service Set IDentifier (also known as the
network name) of the AP.
Channel This field displays the wireless channel the AP is currently using.
Radio Mode The field displays the radio mode the AP is currently using.
Security This field displays the type of wireless encryption the AP is
currently using.
Last Seen This field displays the last time the NWA scanned for the AP.
Description If you want to move the AP’s entry to the friendly AP list, enter a
short, explanatory description identifying the AP before you click
Add to Friendly AP List. A maximum of 32 alphanumeric
characters are allowed in this field. Spaces, underscores (_) and
dashes (-) are allowed.
To Next Page
Loading...
