Chapter 23 Maintenance
NWA-3160 Series User’s Guide
265
23.2.1 System Statistics Screen
Use this screen to view diagnostic information about the NWA. Click Maintenance
> Show Statistics. The following screen pops up.
Note: The Poll Interval field is configurable. The fields in this screen vary according to
the current wireless mode of each WLAN adaptor.
Figure 169 Maintenance > System Status: Show Statistics
The following table describes the labels in this screen.
Table 81 Maintenance > System Status: Show Statistics
LABEL DESCRIPTION
Port This is the Ethernet port (LAN) or wireless LAN adaptor (WLAN).
Status This shows the port speed and duplex setting if you are using
Ethernet encapsulation for the Ethernet port. Ethernet port
connections can be in half-duplex or full-duplex mode. Full-duplex
refers to a device's ability to send and receive simultaneously, while
half-duplex indicates that traffic can flow in only one direction at a
time. The Ethernet port must use the same speed or duplex mode
setting as the peer Ethernet port in order to connect.
This shows the transmission speed only for the wireless adaptors.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Collisions This is the number of collisions on this port.
Tx B/s This shows the transmission speed in bytes per second on this port.
Rx B/s This shows the reception speed in bytes per second on this port.
Up Time This is total amount of time the line has been up.
Poll Interval(s) Enter the time interval for refreshing statistics.
Set Interval Click this button to apply the new poll interval you entered above.
Stop Click this button to stop refreshing statistics.
To Next Page
Loading...
