ZyXEL Communications NWA-3160 - 6.6 Redundancy Screen

Chapter 6 AP Controller Mode
NWA-3160 Series User’s Guide
95
6.6 Redundancy Screen
Use this screen to set the controller AP as a primary or secondary controller.
If you set your NWA as a primary controller AP, you can have a secondary
controller AP to serve as a backup. All configurations are synchronized between
the NWA and the secondary controller AP.
When the NWA is in AP controller mode, click CONTROLLER > Redundancy. The
following screen displays.
Figure 67 The Controller > Redundancy Screen
The following table describes the labels in this screen.
Table 13 The Controller > Redundancy Screen
LABEL DESCRIPTION
Redundancy Select Enable to set the NWA either as a Primary AP
Controller or as a Secondary Controller AP.
Select Disable when the NWA acts as a primary AP
controller without a backup.
Primary AP Controller Select this if the NWA has a secondary controller AP. You
must give the IP address of this backup in the field below.
Secondary IP Enter the IP address of the secondary controller AP.
Secondary AP Controller Select this if the NWA is the secondary controller AP.
Apply Click this to save the changes in this screen.
Reset Click this to return the fields in this screen to their
previously-saved values.