Chapter 20 VLAN
NWA-3160 Series User’s Guide
249
20.3.4 Second Rx VLAN ID Example
In this example, the NWA is configured to tag packets from SSID01 with VLAN ID
1 and tag packets from SSID02 with VLAN ID 2. VLAN 1 and VLAN 2 have
access to a server, S, and the Internet, as shown in the following figure.
Figure 160 Second Rx VLAN ID Example
Packets sent from the server S back to the switch are tagged with a VLAN ID
(incoming VLAN ID). These incoming VLAN packets are forwarded to the NWA.
The NWA compares the VLAN ID in the packet header with each SSID’s configured
VLAN ID and second Rx VLAN ID settings.
In this example, SSID01’s second Rx VLAN ID is set to 2. All incoming packets
tagged with VLAN ID 2 are forwarded to SSID02, and also to SSID01. However,
SSID02 has no second Rx VLAN ID configured, and the NWA forwards only
packets tagged with VLAN ID 2 to it.
20.3.4.1 Second Rx VLAN Setup Example
The following steps show you how to setup a second Rx VLAN ID on the NWA.
1 Log into the Web Configurator.
To Next Page
Loading...
