Chapter 20 VLAN
NWA-3160 Series User’s Guide
250
2 Click VLAN > Wireless VLAN.
3 If VLAN is not already enabled, click Enable Virtual LAN and set up the
Management VLAN ID (see Section 20.3.2 on page 236).
Note: If no devices are in the management VLAN, then no one will be able to access
the NWA and you will have to restore the default configuration file.
4 Select the SSID profile you want to configure (SSID03 in this example), and
enter the VLAN ID number (between 1 and 4094).
5 Enter a Second Rx VLAN ID. The following screen shows SSID03 tagged with a
VLAN ID of 3 and a Second Rx VLAN ID of 4.
Figure 161 Configuring SSID: Second Rx VLAN ID Example
6 Click Apply to save these settings. Outgoing packets from clients in SSID03 are
tagged with a VLAN ID of 3, and incoming packets with a VLAN ID of 3 or 4 are
forwarded to SSID03.
To Next Page
Loading...
