ZyXEL Communications P-660R-T1 - Page 178

P-660 series Support Notes
or interface to be the
Source IP address.
[-p] [Min MTU] [Max MTU]
[Interval size]
Sweep range of sizes.
route
status [if] display routing table
add <dest_addr|default>[/<bits>]
<gateway> [<metric>]
add route
addiface <dest_addr|default>[/<bits>]
<gateway> [<metric>]
add an entry to the
routing table to iface
addprivate <dest_addr|default>[/<bits>]
<gateway> [<metric>]
add private route
drop <host addr> [/<bits>] drop a route
flush flush route table
lookup <addr> find a route to the
destination
errcnt
disp display routing statistic
counters
clear clear routing statistic
counters
status display ip statistic
counters
adjTcp <iface> [<mss>] adjust the TCP mss of
iface
udp
status display udp status
rip
accept <gateway> drop an entry from the
RIP refuse list
activate enable rip
merge [on|off] set RIP merge flag
refuse <gateway> add an entry to the rip
refuse list
request <addr> [port] send rip request to some
address and port
reverse [on|off] RIP Poisoned Reverse
status display rip statistic
counters
trace enable debug rip trace
mode
<iface> in [mode] set rip in mode
<iface> out [mode] set rip out mode
177
All contents copyright © 2005 ZyXEL Communications Corporation.