ZyXEL Communications P-660R-T1 - Page 197

P-660 series Support Notes
196
All contents copyright © 2005 ZyXEL Communications Corporation.
wan backup save Save wan backup related parameters Menu 2
wan backup display Display wan backup configurations Menu 2
wan tredir active [on|off] Set traffic redirect on/off Menu 2.1
wan tredir ip [IP addr] Set traffic redirect gateway IP address Menu 2.1
wan tredir metric [number] Set traffic redirect metric Menu 2.1
wan tredir save
Save traffic redirect related parameters
** Have to apply ?an backup
save?command thereafter
Menu 2.1
wan tredir display Display traffic redirect configurations Menu 2.1
lan index [1|2|3]
1: Select main LAN Interface
2: Select IP Alias 1
3: Select IP Alias 2
Select a LAN interface to edit
Menu 3.2
lan active [on|off] Turn on or off on IP Alias Interface Menu 3.2.1
lan ipaddr [address] [subnet mask]
Set LAN IP address and subnet mask
Example:
> lan ipaddr 192.168.1.1 255.255.255.0
Menu 3.2
lan rip [none|in|out|both]
[rip1|rip2b|rip2m]
Set LAN IP RIP mode and RIP version,
if you choose none in the first parameter,
the second parameter is also necessary
Menu 3.2
lan multicast [none|igmpv1|igmpv2] Set LAN IP multicast mode Menu 3.2
lan filter [incoming|outgoing]
[tcpip|generic] [set#1] [set#2] [set#3]
[set#4]
Set LAN filter to be incoming/outgoing
or protocol /device and the filter set
could be 1-12, 0 means empty
Example:
Lan filter incoming tcpip 1 0 0 0
Menu 3.1
lan dhcp mode [server|relay|none]
Set DHCP mode to
be?erver? ?elay? ?one?o:p>
Menu 3.2
lan dhcp server dnsserver [pri dns]
[sec dns]
Set primary and secondary LAN DNS
server
Menu 3.2
lan dhcp server pool [start-address]
[num]
Set DHCP start address and pool size
Menu 3.2
lan dhcp server gateway [IP address] Set DHCP gateway Menu 3.2
lan dhcp server netmask [subnet
mask]
Set DHCP subnet mask
Menu 3.2