ZyXEL Communications P-660R-T1 - Page 200

P-660 series Support Notes
199
All contents copyright © 2005 ZyXEL Communications Corporation.
edit] [type] [local start IP] [local end
IP] [global start IP] [global end IP]
[server set #]
the ?ype?is not ?nside-server? then
the ?ype?field will still need a dummy
value like ??
Type is 0 - 4 = one-to-one, many-to-one,
many-to-many-overload,
many-to-many-non overload,
inside-server
Example:
> ip nat addrmap rule 1 edit 3
192.168.1.10 192.168.1.20
192.168.10.56 192.168.1.56 0
ip nat addrmap clear [map#] [rule#] Clear the selected rule of the set Menu 15.1
ip nat addrmap freememory Discard Changes Menu 15.1
ip nat addrmap disp Display nat set information Menu 15.1
ip nat addrmap save Save settings Menu 15.1
ip nat server load [set#] Load the server sets of NAT into buffer Menu 15.2
ip nat server disp [1]
?isp 1?means to display the NAT server
set in buffer, if parameter ?? is omitted,
then it will display all the server sets
Menu 15.2
ip nat server save Save the NAT server set buffer into flash Menu 15.2
ip nat server clear [set#]
Clear the server set [set#], must
use ?ave?command to let it save into
flash
Menu 15.2
ip nat server edit [rule#] active
Activate the rule [rule#], rule number is 1
to 24, the number 25-36 is for UPNP
application
Menu 15.2
ip nat server edit [rule#] svrport
<start port> <end port>
Configure the port range from <start port
> to <end port>
Menu 15.2
ip nat server edit [rule#] remotehost
<start IP> <end IP>
Configure the IP address range of remote
host (Leave it to be default value if you
don? need this command)
Menu 15.2
ip nat server edit [rule#] leasetime
<seconds>
Configure the lease time (Leave it to be
default value if you don? want this
command)
Menu 15.2
ip nat server edit [rule#] rulename
<string>
Configure the name of the rule (Leave it
to be default value if you don? want this
command)
Menu 15.2
ip nat server edit [rule#] forwardip
<IP address>
Configure the LAN IP address to be
forwarded
Menu 15.2
ip nat server edit [rule#] protocol Configure the protocol to be used TCP , Menu 15.2