P-660 series Support Notes
198
All contents copyright © 2005 ZyXEL Communications Corporation.
wan node wanip [static|dynamic]
[address]
Set the wan IP address
Menu 11.3
wan node remoteip [address] [subnet
mask]
Set the remote gateway IP address and
subnet mask
Menu 11.3
wan node nat [off | sua | full] [address
mapping #]
Set type wan NAT mode to be off or
SUA or Full feature
Menu 11.3
wan node rip [none|in|out|both]
[rip1|rip2b|rip2m]
Set the wan RIP mode and RIP version
Menu 11.3
wan node multicast
[none|igmpv1|igmpv2]
Set the wan IP multicast mode
Menu 11.3
wan node filter [incoming|outgoing]
[tcpip|generic]
[set #1] [set #2] [set #3] [set #4]
Set WAN filter, incoming or outgoing
can be specified, and filter set can be
1-12, value 0 means empty
Menu 11.5
wan node save
Save the related parameters of WAN
node
wan node display
Display WAN profile configuration in
buffer
Display Menu
11
ip route addrom index [Rule #] Select a Static Route index 1-16 to edit Menu 12.1
ip route addrom name [Name] Set Rule Name Menu 12.1
ip route addrom active [on|off] Set Active or Inactive Flag Menu 12.1
ip route addrom set [dest address/
mask bits] [gateway] [metric]
Set IP static route
Example:
> ip ro addrom set 192.168.1.33/24
192.168.1.1 2
Menu 12.1
ip route addrom private [yes|no] Set Private Flag Menu 12.1
ip route addrom disp
Display both working buffer and Editing
Entry
Menu 12.1
ip route addrom freememory Discard all changes Menu 12.1
ip route addrom save Save edited settings Menu 12.1
ip route addrom clear [Index #] Clear Static Route Index Menu 12.1
ip nat addrmap map [map#] [set
name]
Select NAT address mapping set and set
mapping set name, but set name is
optional
Example:
> ip nat addrmap map 1 myset
Menu 15.1
ip nat addrmap rule [rule#] [insert | Set NAT address mapping rule. If Menu 15.1
To Next Page
Loading...
