P-660 series Support Notes
• Before making a VPN connection from Win9x to WinNT server, you need
to connect P-660 router to your ISP first.
• Enter the IP address of the PPTP server (WinNT server) and the port
number for PPTP as shown below.
ed.
N connection from the Win9x client to the NT server, you need to
net IP address that the ISP assigns to P-660 router in SUA mode
and enter this IP address in the VPN dial-up dialog box. You can check this Internet
Menu 15.2.1 - NAT Server Setup (Used for SUA Only)
Rule Start Port No. End Port No. IP Address
---------------------------------------------------
1. Default Default 0.0.0.0
2. 1723 1723 192.168.1.10
3. 0 0 0.0.0.0
4. 0 0 0.0.0.0
5. 0 0 0.0.0.0
6. 0 0 0.0.0.0
7. 0 0 0.0.0.0
8. 0 0 0.0.0.0
9. 0 0 0.0.0.0
10. 0 0 0.0.0.0
When you have finished the above settings, you can ping to the remote Win9x client
from WinNT. This ping command is used to demonstrate that remote the Win9x can
be reached across the Internet. If the Internet connection between two LANs is
achievable, you can place a VPN call from the remote Win9x client.
11. 0 0 0.0.0.0
12. 0 0 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
For example: C:\ping 203.66.113.2
When a dial-up connection to ISP is established, a default gateway is assigned to the
router traffic through that connection. Therefore, the output below shows the default
gateway of the Win9x client after the dial-up connection has been establish
Before making a VP
know the exact Inter
40
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
