ZyXEL Communications USG40W - Page 1015

Chapter 47 Diagnostics
ZyWALL USG Series User’s Guide
1015
Figure 723 Maintenance > Diagnostics > Wireless Frame Capture > Capture
The following table describes the labels in this screen.
Table 414 Maintenance > Diagnostics > Wireless Frame Capture > Capture
LABEL DESCRIPTION
MON Mode APs
Configure AP to
MON Mode
Click this to go the Configuration > Wireless > AP Management screen, where you can
set one or more APs to monitor mode.
Available MON
Mode APs
This column displays which APs on your wireless network are currently configured for
monitor mode.
Use the arrow buttons to move APs off this list and onto the Captured MON Mode APs
list.
Capture MON Mode
APs
This column displays the monitor-mode configured APs selected to for wireless frame
capture.
Misc Setting
File Size Specify a maximum size limit in kilobytes for the total combined size of all the capture
files on the Zyxel Device, including any existing capture files and any new capture files
you generate.
Note: If you have existing capture files you may need to set this size larger or
delete existing capture files.
The valid range is 1 to 50000. The Zyxel Device stops the capture and generates the
capture file when either the file reaches this size.
File Prefix Specify text to add to the front of the file name in order to help you identify frame
capture files.
You can modify the prefix to also create new frame capture files each time you perform
a frame capture operation. Doing this does no overwrite existing frame capture files.
The file format is: [file prefix].cap. For example, “monitor.cap”.