ZyXEL Communications USG40W - The VPN Gateway Add;Edit Screen

Chapter 30 IPSec VPN
ZyWALL USG Series User’s Guide
620
Each field is discussed in the following table. See Section 30.3.1 on page 620 for more information.
30.3.1 The VPN Gateway Add/Edit Screen
The VPN Gateway Add/Edit screen allows you to create a new VPN gateway policy or edit an existing
one. To access this screen, go to the VPN Gateway summary screen (see Section 30.3 on page 619),
and click either the Add icon or an Edit icon.
Table 222 Configuration > VPN > IPSec VPN > VPN Gateway
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
References Select an entry and click References to open a screen that shows which settings use the
entry. See Section 10.5.4 on page 328 for an example.
# This field is a sequential value, and it is not associated with a specific VPN gateway.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
Name This field displays the name of the VPN gateway
My address This field displays the interface or a domain name the Zyxel Device uses for the VPN gateway.
Secure Gateway This field displays the IP address(es) of the remote IPSec routers.
VPN Connection This field displays VPN connections that use this VPN gateway.
IKE Version This field displays whether the gateway is using IKEv1 or IKEv2. IKEv1 applies to IPv4 traffic only.
IKEv2 applies to both IPv4 and IPv6 traffic. IKE (Internet Key Exchange) is a protocol used in
setting up security associations that allows two parties to send data securely. See Section 30.1
on page 605 for more information on IKEv1 and IKEv2.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.