Chapter 43 Object
ZyWALL USG Series User’s Guide
827
43.3.2.6 Add/Edit MAC Filter Profile
This screen allows you to create a new MAC filtering profile or edit an existing one. To access this screen,
click the Add button or select a MAC filter profile from the list and click the Edit button.
Figure 569 SSID > MAC Filter List > Add/Edit MAC Filter Profile
The following table describes the labels in this screen.
43.4 MON Profile
43.4.1 Overview
This screen allows you to set up monitor mode configurations that allow your connected APs to scan for
other wireless devices in the vicinity. Once detected, you can use the Rogue AP screen (Section 9.4 on
page 288) to classify them as either rogue or friendly and then manage them accordingly.
Table 311 SSID > MAC Filter List > Add/Edit MAC Filter Profile
LABEL DESCRIPTION
Profile Name Enter up to 31 alphanumeric characters for the profile name. This name is only visible in the Web
Configurator and is only for management purposes. Spaces and underscores are allowed.
Filter Action Select allow to permit the wireless client with the MAC addresses in this profile to connect to the
network through the associated SSID; select deny to block the wireless clients with the specified
MAC addresses.
Add Click this to add a MAC address to the profile’s list.
Edit Click this to edit the selected MAC address in the profile’s list.
Remove Click this to remove the selected MAC address from the profile’s list.
# This field is a sequential value, and it is not associated with a specific profile.
MAC Address This field specifies a MAC address associated with this profile.
Description This field displays a description for the MAC address associated with this profile. You can click the
description to make it editable. Enter up to 60 characters, spaces and underscores allowed.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
