Chapter 9 Wireless
ZyWALL USG Series User’s Guide
293
• Ekahau RTLS Controller in blink mode with TZSP Updater enabled
• Security policies to allow RTLS traffic if the Zyxel Device security policy control is enabled or the Ekahau
RTLS Controller is behind a firewall.
For example, if the Ekahau RTLS Controller is behind a firewall, open ports 8550, 8553, and 8569 to allow
traffic the APs send to reach the Ekahau RTLS Controller.
The following table lists default port numbers and types of packets RTLS uses.
9.6.3 Configuring RTLS
Click Configuration > Wireless > RTLS to open this screen. Use this screen to turn RTLS (Real Time Location
System) on or off and specify the IP address and server port of the Ekahau RTLS Controller.
Figure 235 Configuration > Wireless > RTLS
The following table describes the labels in this screen.
Table 99 RTLS Traffic Port Numbers
PORT NUMBER TYPE DESCRIPTION
8548 TCP Ekahau T201 location update.
8549 UDP Ekahau T201 location update.
8550 TCP Ekahau T201 tag maintenance protocol and Ekahau RTLS Controller user interface.
8552 UDP Ekahau Location Protocol
8553 UDP Ekahau Maintenance Protocol
8554 UDP Ekahau T301 firmware update.
8560 TCP Ekahau Vision web interface
8562 UDP Ekahau T301W firmware update.
8569 UDP Ekahau TZSP Listener Port
Table 100 Configuration > Wireless > RTLS
LABEL DESCRIPTION
Enable Select this to use Wi-Fi to track the location of Ekahau Wi-Fi tags.
IP Address Specify the IP address of the Ekahau RTLS Controller.
Server Port Specify the server port number of the Ekahau RTLS Controller.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
