ZyXEL Communications USG40W - Address Group Summary Screen

Chapter 43 Object
ZyWALL USG Series User’s Guide
845
The following table describes the labels in this screen.
43.7.3 Address Group Summary Screen
The Address Group screen provides a summary of all address groups. To access this screen, click
Configuration > Object > Address/Geo IP > Address Group. Click a column’s heading cell to sort the
table entries by that column’s criteria. Click the heading cell again to reverse the sort order.
Figure 585 Configuration > Object > Address/Geo IP > Address Group
Table 325 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
LABEL DESCRIPTION
Name Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Object Type Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface’s IP address, subnet, or gateway if the interface’s IP address settings
change. For example, if you change 1’s IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
IPv6 Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
IPv6 Starting
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
IPv6 Ending
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
IPv6 Address
Prefix
This field is only available if the Address Type is SUBNET. This field cannot be blank. Enter the IPv6
address prefix that the Zyxel Device uses for the LAN IPv6 address.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
IPv6 Address Type Select whether the IPv6 address is a link-local IP address (LINK LOCAL), static IP address
(STATIC), an IPv6 StateLess Address Auto Configuration IP address (SLAAC), or is obtained from
a DHCPv6 server (DHCPv6).
Region If you selected Geography as the Address Type, use this field to select a country or continent.
FQDN If you selected FQDN as the Address Type, use this field to enter a fully qualified domain name.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.