Chapter 44 System
ZyWALL USG Series User’s Guide
907
• Use the System > IPv6 screen (see Section 44.16 on page 958) to enable or disable IPv6 support on the
Zyxel Device.
• Use the System > ZON screen (see Section 44.17 on page 958) to enable or disable the Zyxel One
Network (ZON) utility that uses Zyxel Discovery Protocol (ZDP) for discovering and configuring ZDP-
aware Zyxel devices in the same network as the computer on which ZON is installed.
Note: See each section for related background information and term definitions.
44.2 Host Name
A host name is the unique name by which a device is known on a network. Click Configuration > System
> Host Name to open the Host Name screen.
Figure 633 Configuration > System > Host Name
The following table describes the labels in this screen.
44.3 USB Storage
The Zyxel Device can use a connected USB device to store the system log and other diagnostic
information. Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and use the
FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Table 362 Configuration > System > Host Name
LABEL DESCRIPTION
System Name Enter a descriptive name to identify your Zyxel Device device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Domain Name Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes “-” are accepted.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
