Chapter 21 Hotspot
ZyWALL USG Series User’s Guide
532
21.5 The Billing > Discount Screen
Use this screen to configure a custom discount pricing plan. This is useful for providing reduced rates for
purchases of longer periods of time. You can charge higher rates per unit at lower levels (fewer units
purchased) and lower rates per unit at higher levels (more units purchased). Click Configuration >
Hotspot > Billing > Discount to open the following screen.
Note: The discount price plan does not apply to users who purchase access time online with a
credit card.
Quota Type The quota settings section is NOT available when you set Accounting Method to Time to Finish
in the Billing > General screen.
Set a limit for the user accounts. This only applies to user’s traffic that is received or transmitted
through the WAN interface.
Note: When the limit is exceeded, the user is not allowed to access the Internet
through the Zyxel Device.
Select Total to set a limit on the total traffic in both directions.
Select Upload/Download to set a limit on the upstream traffic and downstream traffic
respectively.
Total Quota If you select Total, specify how much downstream and/or upstream data (in MB (Megabytes)
or GB (Gigabytes)) can be transmitted through the WAN interface before the account expires.
0 means there is no data limit for the user account.
Upload Quota If you select Upload/Download, specify how much upstream data (in MB (Megabytes) or GB
(Gigabytes)) can be transmitted through the WAN interface before the account expires.
0 means there is no data limit for the user account.
Download Quota If you select Upload/Download, specify how much downstream data (in MB (Megabytes) or GB
(Gigabytes)) can be transmitted through the WAN interface before the account expires.
0 means there is no data limit for the user account.
Enable
Bandwidth
Select this option to turn on bandwidth management for the user accounts.
Upload Specify the maximum outgoing bandwidth allowed for the user account in kilobits per second.
Upload refers to the traffic the Zyxel Device sends out from a user.
Download Specify the maximum incoming bandwidth allowed for the user account in kilobits per second.
Download refers to the traffic the Zyxel Device sends to a user.
Priority Enter a number between 1 and 7 to set the priority for the user’s traffic. The smaller the number,
the higher the priority.
Traffic with a higher priority is given bandwidth before traffic with a lower priority.
Note: The priority setting here has priority over the priority setting in a bandwidth
management rule.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
Table 182 Configuration > Hotspot > Billing > Billing Profile > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
