Chapter 7 Monitor
ZyWALL USG Series User’s Guide
198
• Use the Log > View Log screen (see Section 7.37.1 on page 260) to view the Zyxel Device’s current log
messages. You can change the way the log is displayed, you can e-mail the log, and you can also
clear the log in this screen.
• Use the Log > View AP Log screen (see Section 7.37.2 on page 262) to view the Zyxel Device’s current
wireless AP log messages.
• Use the Log > Dynamic Users Log screen (see Section 7.37.3 on page 264) to view the Zyxel Device’s
dynamic guest account log messages.
7.2 The Port Statistics Screen
Use this screen to look at packet statistics for each Gigabit Ethernet port. To access this screen, click
Monitor > System Status > Port Statistics.
Figure 167 Monitor > System Status > Port Statistics
The following table describes the labels in this screen.
Table 36 Monitor > System Status > Port Statistics
LABEL DESCRIPTION
Poll Interval Enter how often you want this window to be updated automatically, and click Set Interval.
Set Interval Click this to set the Poll Interval the screen uses.
Stop Click this to stop the window from updating automatically. You can start it again by setting the
Poll Interval and clicking Set Interval.
Switch to Graphic
View
Click this to display the port statistics as a line graph.
# This field is a sequential value, and it is not associated with a specific port.
Port This field displays the physical port number.
Status This field displays the current status of the physical port.
Down - The physical port is not connected.
Speed / Duplex - The physical port is connected. This field displays the port speed and duplex
setting (Full or Half).
TxPkts This field displays the number of packets transmitted from the Zyxel Device on the physical port
since it was last connected.
To Next Page
Loading...
