ZyXEL Communications USG40W - Chapter 9 Wireless; Overview; What You Can Do in this Chapter; Controller Screen

ZyWALL USG Series User’s Guide
273
CHAPTER 9
Wireless
9.1 Overview
Use the Wireless screens to configure how the Zyxel Device manages supported Access Points (APs).
Supported APs should be in managed mode. See the product page Licenses tab for a list of supported
APs.
Note: See Section 1.1 on page 28 to see which models have built-in Wi-Fi functionality and
which models do not support the AP controller function.
9.1.1 What You Can Do in this Chapter
• Use the Controller screen (Section 9.2 on page 273) to set how the Zyxel Device allows new APs to
connect to the network and set the country code of APs that are connected to the Zyxel Device.
• Use the AP Management screens (Section 9.3 on page 274) to manage all of the APs connected to
the Zyxel Device.
• Use the Rogue AP screen (Section 9.4 on page 288) to assign APs either to the rogue AP list or the
friendly AP list.
• Use the Auto Healing screen (Section 9.5 on page 291) to extend the wireless service coverage area
of the managed APs when one of the APs fails.
• Use the RTLS screen (Section 9.6 on page 292) to allow managed APs with battery-powered Wi-Fi tags
be part of Ekahau RTLS (Real Time Location Service). RTLS can track the location of APs managed by
the Zyxel Device to create maps, alerts, and reports.
9.2 Controller Screen
Use this screen to set how the Zyxel Device allows new APs to connect to the network. Click
Configuration > Wireless > Controller to access this screen.
Figure 224 Configuration > Wireless > Controller