Chapter 10 Interfaces
ZyWALL USG Series User’s Guide
370
In this example, virtual Ethernet interface lan1:1 is also removed from the routing table when lan1 is
added to br0. Virtual interfaces are automatically added to or remove from a bridge interface when
the underlying interface is added or removed.
10.10.1 Bridge Summary
This screen lists every bridge interface and virtual interface created on top of bridge interfaces. If you
enabled IPv6 in the Configuration > System > IPv6 screen, you can also configure bridge interfaces used
for your IPv6 network on this screen. To access this screen, click Configuration > Network > Interface >
Bridge.
Figure 268 Configuration > Network > Interface > Bridge
Each field is described in the following table.
Table 124 Configuration > Network > Interface > Bridge
LABEL DESCRIPTION
Configuration / IPv6
Configuration
Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section
for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections
have similar fields as described below.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Create Virtual
Interface
To open the screen where you can create a virtual interface, select an interface and click
Create Virtual Interface.
References Select an entry and click References to open a screen that shows which settings use the
entry. See Section 10.5.4 on page 328 for an example.
# This field is a sequential value, and it is not associated with any interface.
To Next Page
Loading...
